New Electronics Enclosure

This is my newly-designed, nearly-completed, CNC electronics enclosure. I made this from a combination of 5mm and 6mm plywood that was sitting around the shop. The end-panels were cut to accept 60mm fans (one on each end of the machine) to keep the insides cool. I added the OpenBuilds and OX logos because it looked a little barren without anything on that side of the enclosure. ...

Baseball Plaque

I was trying to figure out the process for sign/plaque engraving, so I put together a little baseball plaque for my son. This is edge-glued spruce with a pecan stain and polyurethane. ...

Rounded Corner Jigs

I have been working with my router on some shop carts, and I needed a way to accurately round-off the corners on one of the cart tops I was making. I decided to use the CNC machine to cut some templates in varying sizes for the future. Pictured here are the “raw” templates that will have aluminum angle attached to two sides. Using these is super-simple! Simply hold the jig against the work piece and use a bearing-bit in the table-mount router to follow the corner – tada! I also used the CNC to engrave the corner radius engraved on each. There is nothing quite like having my tools make tools! ...

Ballerina Hanger

After seeing this on Pinterest, I decided that I needed to make one for my daughter in English. I designed a set of vector files for it, and then cut them out of basic plywood on my Ox CNC. ...